AUDIT: Stop waiting for backlog after audit_panic() happens

We force a rate-limit on auditable events by making them wait for space 
on the backlog queue. However, if auditd really is AWOL then this could 
potentially bring the entire system to a halt, depending on the audit 
rules in effect.

Firstly, make sure the wait time is honoured correctly -- it's the 
maximum time the process should wait, rather than the time to wait 
_each_ time round the loop. We were getting re-woken _each_ time a 
packet was dequeued, and the timeout was being restarted each time.

Secondly, reset the wait time after audit_panic() is called. In general 
this will be reset to zero, to allow progress to be made. If the system
is configured to _actually_ panic on audit_panic() then that will 
already have happened; otherwise we know that audit records are being 
lost anyway. 

These two tunables can't be exposed via AUDIT_GET and AUDIT_SET because 
those aren't particularly well-designed. It probably should have been 
done by sysctls or sysfs anyway -- one for a later patch.

Signed-off-by: David Woodhouse <dwmw2@infradead.org>