Skip to content
Commit 4018517a authored by Johannes Berg's avatar Johannes Berg Committed by John W. Linville
Browse files

iwlagn: fix RX skb alignment



So I dug deeper into the DMA problems I had with iwlagn and a kind soul
helped me in that he said something about pci-e alignment and mentioned
the iwl_rx_allocate function to check for crossing 4KB boundaries. Since
there's 8KB A-MPDU support, crossing 4k boundaries didn't seem like
something the device would fail with, but when I looked into the
function for a minute anyway I stumbled over this little gem:

	BUG_ON(rxb->dma_addr & (~DMA_BIT_MASK(36) & 0xff));

Clearly, that is a totally bogus check, one would hope the compiler
removes it entirely. (Think about it)

After fixing it, I obviously ran into it, nothing guarantees the
alignment the way you want it,  because of the way skbs and their
headroom are allocated. I won't explain that here nor double-check that
I'm right, that goes beyond what most of the CC'ed people care about.

So then I came up with the patch below, and so far my system has
survived minutes with 64K pages, when it would previously fail in
seconds. And I haven't seen a single instance of the TX bug either. But
when you see the patch it'll be pretty obvious to you why.

This should fix the following reported kernel bugs:

http://bugzilla.kernel.org/show_bug.cgi?id=11596
http://bugzilla.kernel.org/show_bug.cgi?id=11393
http://bugzilla.kernel.org/show_bug.cgi?id=11983

I haven't checked if there are any elsewhere, but I suppose RHBZ will
have a few instances too...

I'd like to ask anyone who is CC'ed (those are people I know ran into
the bug) to try this patch.

I am convinced that this patch is correct in spirit, but I haven't
understood why, for example, there are so many unmap calls. I'm not
entirely convinced that this is the only bug leading to the TX reply
errors.

Signed-off-by: default avatarJohannes Berg <johannes@sipsolutions.net>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 8e3bad65
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment